Thermoplastic Automotive mold with slider mechanism actuated by guide pin
| SPECIFICATION | |
| Usage | Automotive article-automotive interior trim |
| Mold type | Thermoplastic hot runner system injection mold |
| Raw material | PC+ABS |
| Finishing | Technical Polishing and VDI 23#, |
| Cavity No. | 1 Cav. |
| Construction | 2-plate, Guide pin in Cavity side. |
| Demold mechanism | Slider x 2, angular lifter x 4, floating core slider actuated by cavity locker x 1. |
| Injection | Hot runner system x one hot drop. Brand Synventive |
| Mold material | Gröditz 1.2344 ESR 48-52 HRC, lifer hardened and nitrided HV950 |
| Mold size | L450xW350xH490mm, |
| Components | HASCO ejection pins, waterline plugs, slider retainers. |
| Machine Tonnage | M/C HT180T, |
| Cycle time | 33 sec, mold temperature 60°C. |
| Mold lifetime | 1,000,000 shots |
| FA lead-time | 5 weeks at order released |
| Delivery time | 12 weeks after order. |
| Automotive thermoplastic hot runner injection mold (formenbau), automotive article-automotive interior trim, automotive Interior Parts. The aftermarket encompasses parts for replacement, collision, appearance and performance, including electric propulsion, Good quality is very important in appearance, including matching line, surface roughness, graining. so parting line matching is very tight to get good part appearance in the mold fabrication. Shut-off area, parting line step and sharp edge always be focused on during the whole processing. as well as parting line interlock with precision pocketing position. Waterline connectors were directedly joined to mold cores through A/B plates of mold base to get efficient cooling affection. The wedge block for slider mechanisms is cut in solidity on mold base plate to avoided of solder moves back while sudden injection shots. This is a must as condition of keeping good parting line matching for good part appearance. Mold quality control is applied during complete thermoplastic injection mold frication process. 4 supporting balance plates are put on the corners of plates, through guide pins. Mold sourcing in China from Europe easily to find Europe mold making standard is common here. Texture VDI23#,a fine grain grade, was applied to cavity surface after T1 (First article) mold trial. The method of sequence is common for us to do texture. The cavity surface should not be textured until plastic parts have a good dimension measuring report and good appearance. also before texture is copied to cavity surface, customer's authorization should be released to NEOK. to avoided of part model modification in future. To hot runner system mold, texture is easy to be copied from cavity surface. Mold plates is made of prehardened material 1.2312, 28 HRC. Support wear plate is made of material 1.2510, 60-62 HRC if inquiry to custom by thermo plastic mould sourcing in Asia, please not hesitate to contact NEOK sales team. Yours sincerely ! Welcome your guiding idea. |
|
