Automotive article-automotive interior trim-venting part

Short Description:

Good fitting of sliders and cores was completed by CNC milling or EDM process.Moldbase material 1.2312 prehardened. Slider blocks was nitrided with hardness deviation of 5 HRC to cores', Hot nozzle trans to cold subgate on side wall.HASCO components ,such as water line connectors, ejection pins, dowel bush-pins on square blocks.

Usage: Automotive article-automotive interior trim-venting part

Mold type: Thermoplastic hot runner system injection mold

Raw material: PC+ABS

Cavity No.: 1 Cav.

Demold mechanism: Slider x 3 actuated by long guide pins and locked by solid wedge.

Mold material: Gröditz 1.2344 ESR 48-52 HRC, ejection plates 1.2312. A/B plates 1.2312.

Mold size: L450xW350xH500mm,

Send email to us

Product Detail

Product Tags

SPECIFICATION
Usage	Automotive article-automotive interior trim-venting part
Mold type	Thermoplastic hot runner system injection mold
Raw material	PC+ABS
Finishing	Technical Polishing B2 , interior A3.
Cavity No.	1 Cav.
Construction	2-plate, Guide pin in Cavity side.
Demold mechanism	Slider x 3 actuated by long guide pins and locked by solid wedge.
Injection	Hot runner system x single hot nozzle. Brand Synventive
Mold material	Gröditz 1.2344 ESR 48-52 HRC, ejection plates 1.2312. A/B plates 1.2312.
Mold size	L450xW350xH500mm,
Components	HASCO ejection pins, waterline plugs, slider retainers.
Machine Tonnage	M/C HT180T,
Cycle time	32 sec, mold temperature 60°C.
Mold lifetime	1,000,000 shots
FA lead-time	5 weeks since order released
Delivery time	12 weeks since order released.

Automotive thermoplastic hot runner injection mould, automotive article-automotive interior trim, automotive Interior. Good part appearance client focused on, including matching line.so parting line matching was got from precision fabrication. Good mold design Shut-off anger and position line, as well as keeping parting line to be sharp edge. All bench fitting on sliders and cores was completed by CNC milling or EDM process. Direct waterline connectors rod is to mold cores through mold base plates to let efficient cooling affection. for saving mold base size, clamping location was cut in mold plate to to avoid of usage injection machine 200T. The wedge blocks for slider mechanisms is cut in solidity on mold base plate to avoided of solder moves back while sudden injection shots. This is a must as condition of keeping good parting line matching for good part appearance. Molding technology results in good production on condition of good mold design. All ejection pins were marked numbers and cut out a retaining flat on the pin end. some pins were grinded partial flat for venting.as well as high precision mold cores and inserts. 4x parting line supporting plates for balance are put on the 4 corners of plates, through guide pins, material 1.2510 60-62 HRC. Mold plates is made of prehardened material 1.2312, 28 HRC. other wear plate is made of material 1.2510, 60-62 HRC 5 hours pilot running in press to check mold mechanism operation before deliver and then QC team take departure of the mold to disassembly checking if relevant components exists galling, crack or not, Any inquiry , please not hesitate to contact NEOK sales team. Yours sincerely ! Welcome your guiding idea.