Automotive interior product hot runner mold-automotive upholstery

Short Description:

Automotive interior trim hot runner mold, mold lifetime 1 million of shots. Samples off mold were not deformed and conformed to mold flow analysis report. The material of core blocks were purchased from Europe steel sales agency in China, published material certificate for customer's requirement. Good quality on part appearance.

Usage: Automotive article-automotive interior trim part.

Mold type: Thermoplastic injection mould with hot runner system.

Raw material: PC+ABS

Cavity No.: 1 Cav.

Demold mechanism: Slider x 2, core slider actuated by cavity straight bar

Mold material: Gröditz 1.2344 ESR 48-52 HRC, Hardened slider nitrided HV950

Mold size: L450xW350xH490mm,

Send email to us

Product Detail

Product Tags

SPECIFICATION
Usage	Automotive article-automotive interior trim part.
Mold type	Thermoplastic injection mould with hot runner system.
Raw material	PC+ABS
Finishing	Polishing and texture VDI23#
Cavity No.	1 Cav.
Construction	2-plate,slider on bottom of B plate, Guide pin in A plate of Cavity side.
Demold mechanism	Slider x 2, core slider actuated by cavity straight bar
Injection	Hot runner system Brand Synventive x one hot drop.
Mold material	Gröditz 1.2344 ESR 48-52 HRC, Hardened slider nitrided HV950
Mold size	L450xW350xH490mm,
Components	HASCO ejection pins, waterline plugs, slider retainers.
Machine Tonnage	HaiTian180T,
Cycle time	33 sec, mold temperature 60°C by hot water.
Mold lifetime	1,000,000 shots
FA lead-time	5 weeks after 3D mold design approved.
Delivery time	12 weeks since order released.

Automotive interior trim mold with hot runner is for Automotive Interior trim parts. Moldflow analysis is at part deformation or not. actually on mold trial, there is no deformation of samples off press. main reason is advanced Mold Engineering Solution of mold filling analysis. Waterline connectors were directedly through plates of mold base to mold core blocks, so that cooling becomes more effective. The wedge block for slider mechanisms is cut in solidity on mold base plate. Mold plates are made of prehardened steel Gröditz 1.2312 original from Europe, Supporting wear-plates are made of steel O1, 60-62 HRC, and more additional 4 supporting wear-plates are on the corners of plates. material of core blocks is 1.2343 ESR,48-52 HRC. China Mold sourcing of European clients should aim at low cost molds and short delivery time with mold quality. At T1 first article stage, mold cavity finishing is polished 600#. T1 mold trial is just to check mismatching, sink marks, double checking shrinkage, mold running, mold runner etc. on good condition of engineering design or not. once all is set, texture is to be applied on cavity finishing. During pilot molding production, the part can be very easily taken off press by robotic. if you need plastic mould sourcing in Asia for Mold Engineering Solution, please not hesitate to contact NEOK. NEOK does her best to be your good mold supplier in China. Yours sincerely ! Looking forward to you inquiry and offer in 24 hours.